T1 over IP for Voice and Data
E1 over IP for Voice and Data

Other Products
IP-Tube-T1
IP-Tube-E1
Multiplexers
Channel Banks
Voice Compression
Echo Cancellers
T1 E1 Converter

Test Instruments
Digital Multimeter
Analog Multitester
Clamp Meter

IP-Tube QE1 / IP-Tube QT1

Enable One to Four E1 interfaces for E1 over IP Voice and Data The IP•Tube QE1 / IP•Tube QT1 is available with one to four E1 / T1 interfaces and dual 10/100 BaseT Full/ Half Duplex Ethernet Interfaces. The E1 / T1 interfaces have configurations that for provide independent protocol, compression, packet sizing, buffering, clocking, framing, coding and channel settings. Enable additional E1 / T1 Ports as needs expand using a software-based license key. The protocols supported are IPTube, CESoIP, and HDLCoIP.
IP•Tube QE1 Features
Transparent Interconnect The IP•Tube QE1’s / IP•Tube QT1's transparent operation maintains the proprietary signaling required to support PBX features such as call conferencing, call forwarding, caller ID and SS7. Legacy phone equipment investment is preserved. Transparent support for Modem, Fax, or Data circuits. Voice quality is not compromised.
Lossless Data Compression Option The IP•Tube-E1C / IP•Tube QT1C detects idle/redundant data within each DS0 resulting in as much as 56 to 1 / 40 to 1 bandwidth savings. E1 over IP / T1 over IP bandwidth is not consumed by silent or redundant circuits. Management of the IP•Tube E1 / IP•Tube T1is accomplished with a Command Line Interface that is accessed through a Console or Telnet connection. Common templates provide for cut and Paste configuration.
Service Quality Packet Prioritizing The IP•Tube QE1 / IP•Tube QT1 uses the Type of Service byte in the IP packets to prioritize the encapsulated E1 frames. The setting of the TOS byte can be used to ensure that the real time TDM data from the IP•Tube QE1 / IP•Tube QT1 is ensured high priority.
Alternator Load Balancing Option The IP•Tube QE1A / IP•Tube QT1A Alternator option alternatively sends the IP packetized E1 / T1 frames on LAN 1 and LAN 2. The Alternator option enables fractional and full E1 / T1 circuits to be split over two IP WAN connections such as xDSL. The Lossless Data Compression option can be combined with the Alternator option to minimize the bandwidth required from the alternative paths. The cost of interconnecting E1 / T1 communication systems across packetized xDSL is a fraction of long distance leased E1 / T1 circuit costs.
Pay-As-You-Grow Field Upgrades The IP-Tube QE1/ QT1 are designed for Pay-As-You-Go growth from 1 E1 thru 4 E1s / 1 thru 4 T1s per IP•Tube QE1 / IP•Tube QT1. Customers can elect to economize initial network installations, by purchasing their IP-Tube QE1 / IP•Tube QT1 with a single active E1 / T1 port. As the network grows enable additional E1 / T1 Ports via a software-based license key. Field upgrade benefits are extended to our Industry-Best Lossless Data Compression. Just as E1 / T1 ports are field upgradeable, so is Lossless Data Compression. At any time, each E1 / T1 port on the IP-Tube QE1 / IP•Tube QT1 can be upgraded to Lossless Data Compression with a simple software-based license key installation. If upon installation, you determine that your IP•Tube QE1s / IP•Tube QT1s are best deployed with Lossless Data Compression, you're still in business with the per port field upgrade!
VPN Network Management Interconnecting the IP•Tube QE1 / IP•Tube QT1 through a Virtual Private Network with a sufficient real time committed information rate ensures that the required quality of service is provisioned. The IP•Tube QE1's / IP•Tube QT1's second Ethernet interface provides a management port when the first Ethernet interface is connected to a VPN. Each Ethernet LAN interface features independent IP network configurations.
Rack Mount Kit The IP-Tube family is ready for your most demanding central office or data center environments. With the Rack Mount Kit, IP•Tube products are easily installed in 19" and 23" racks. Easy access to both front and rear sides facilitates technician maintenance procedures

Technical Specifications

x Quality of Service Support: • IP Type of Service (TOS) CLI configurable • IANA Registered UDP Port 3175   Regulatory: • CE • Safety -IEC60950 • EMC - CFR 47 Part 15 Sub Part B:2002,   EN55022: 1994+A1&A2, EN55024,   ICES-003 1997, CISPR 22 Level A • Telecom TBR12, TBR13   Management: • Telnet support with Edit and Paste Template Files • Console Port for Out of Band Management • SNMP support (MIB I, MIB II) with configurable traps • Remote config., monitoring, & reset • Telco Diagnostics: Local Loop, Remote Loop   x Dimensions: 14" (L) x 5.5” (W) x 2.50” (H) x Rear Panel/Power: • 12-24 VAC/VDC, 1.0A. International Adapters Available • Optional -48V 0.25 Amp • Hot Standby with 2nd Power Module

LAN Network Interface: • Two 10/100BaseT Full/Half Ethernet • Autonegotiation or Configurable Speed and Duplex LAN Network Protocols Supported: • IP, TCP, UDP, ICMP x 1 to 4 Duplicate Packet Transmission: • Resilient performance through a lossy interconnect. E1/Fractional E1 Specifications: · One to Four Port CSU/DSU Models · Connects directly to E1 Line   or to a DS1  with a Crossover Cable · Framing - CRC4, FAS or Unframed · Coding - HDB3 or AMI · Supports DS0 assignments from 1 to 31 · DS0 Configuration x-y,z...Supported E1 Over IP Protocol: • TDM Over IP • Circuit Extension Services Over IP - CESOIP • HDLC Over IP - HDLCOIP • Frames Per Packet Configurable 8 to 40 • Low Latency Mode: 1 millisecond 8 E1 frames • Max Payload Mode: 5 millisecond 40 E1 frames • Comprehensive Clocking: Internal, Network, Adaptive Lossless Data Compression Option: • Detects idle and redundant data within each DS0 • Configurable Silence Detection Range • Interconnect bandwidth is not consumed by silent   or redundant data • Compression settings from 8 to 1 to 40 to 1 x TFTP Online Upgrade Capable (FLASH ROMs) • IPTube is fully operational during upgrade

IP-Tube-T1-ECAN / IP-Tube-E1-ECAN Applications:

Bhumika Integrated Voice and Data over IP:

Our Voice and Data Multiplexers along with our IP-Tube-E1 provide an excellent solution to terminate all your Voice, Data and Video over an IP interconnect. TDM over IP is a great alternative to traditional Voice over IP as it maintains all existing PBX features and preserves bandwidth.

 

Integrated with our Voice and Data Multiplexers, it provides a great solution for terminating Voice (FXO, FXS, E&M) and Data (RS232, V.24, V.35, V.36, Fractional E1 etc.) traffic over IP.
 

Voice Interfaces: FXO FXS E&M (2 Wire and 4 Wire) FXS-FXS (Hot-line)

Data Interfaces: RS232 G.703 @ 64 Kbps, co-directional IDSL @ 128 Kbps V.35, n X 64 Kbps V.36, n X 64 Kbps X.21, n X 64 Kbps RS530, n X 64 Kbps G.SHDSL, n X 64 Kbps 10BaseT - Ethernet Bridge 10BaseT - Router

Click on the application diagram to get a detailed overview of this application.

Businesses incur significant recurring monthly costs for rigid bandwidth leased lines used purely for the inter-connection of PBXs and tele-com switches. The IPTube-QT1 provides the ability to interconnect existing phone systems over flexible bandwidth lines that are used to carry data, voice, and video. Voice Only Leased Line Toll charges assessed by long distance and local carriers are eliminated by transporting voice and fax traffic across the enterprise intranet, LAN, MAN or WAN.

LANs:
The most compelling option for the interconnection of T1 / E1 based systems is when it can be accomplished over a Local Area Network. The deployment of Fiber based LANS such as FDDI and Gigabit Ethernet, provides organizations with high performance and high quality bandwidth that is especially well suited for the interconnection of PBXs and Telecom Switches.

WANs:
Wide Area Networks that have sufficient bandwidth and Quality of Service provisioning result very significant cost savings especially for Multinational Corporations. The IP•Tube T1C / IP•Tube E1C, a model with lossless data compression, detects idle and redundant data within each voice circuit resulting in a 56 to 1 bandwidth savings. WAN bandwidth is not consumed by silence or redundant samples.

IP Cellullar Back Haul:
IP•Tube T1's / IP•Tube E1's are used to provide transparent interconnection of the base stations (BTSs), base station controllers (BSCs) and mobile switching centers (MSCs) over IP/Ethernet packet-switched networks. Supported access media include fiber, coax and fixed wireless. Cellular phone service providers are able to save substantially by converting to a packet-switch network from circuit TDM lease lines. The IP•Tube T1 / IP•Tube E1 has the duplicate packets transmission and reception feature that provides for resilient performance through a lossy interconnect.

Wireless Ethernet:
Connecting phone systems across a wireless Ethernet connection has a return on investment that is measured in weeks. Eliminating the wired connection for the T1 / E1 based communication equipment is made possible with the IP•Tube’s T1 Over Ethernet / E1 Over Ethernet capability.

IP/Ethernet Service Providers:
Companies, that are able to provide IP/Ethernet access networks generate new revenue by offering traditional T1 / E1 leased line and private line services, such as:

• Cable operators: Cable operators connect traditional T1 / E1 leased line and private line services over their hybrid fiber coax (HFC) cable networks.

• Metropolitan Area Networks: Metropolitan carriers with IP or Broadband Ethernet access networks deliver traditional leased and private line services.

• Utilities: Utilities generate new revenue by offering traditional T1 / E1 leased line and private line services over their fiber or power line networks.

CLEC PBX Back Haul:
The IP•Tube T1 / IP•Tube E1 provides CLECs with a way to back haul T1 / E1 DS0s from a customer’s phone systems over their Internet connection. The back hauled DS0s are connected to the CLECs phone switch for connection to the Public Switched Telephone Networks. Competitive Local Exchange Carriers are able to provide customers with a very economical alternative to the local Phone Company since the Local Loop charges for each phone line are consolidated

Home     |     About Us     |    Products    |    Testing Instruments
Contact Us    |    E-mail

Bhumika International Inc
Mississauga, Ontario, Canada
Phone: + 1 (416) 930 2931
E-mail: info@bhumika.ca
Website: http://www.bhumika.ca

Technical Specifications are subject to change without notice.
Windows is the registered Trademark of Microsoft Corporation, USA.
All other trademarks are the ownership of their respective owners.