LAN-to-LAN IP Bridge

IP-Tube E²
Technical Specifications
Application

Other Products
IP-Tube-T1
IP-Tube-E1
Multiplexers
Channel Banks
Voice Compression
Echo Cancellers
T1 E1 Converter

Test Instruments
Digital Multimeter
Analog Multitester
Clamp Meter

 IP-Tube E²

The IP·Tube E2 is used to interconnect Ethernet LANs through an IP network. Ethernet frames that are destined for a device located on the remote network are encapsulated into IP packets. The IP packets, with the encapsulated Ethernet frames, are sent to the IP address of the destination network's IP·Tube E2 where the IP envelope is removed and the original Ethernet Frames are delivered to the destination network's Ethernet device.

Legacy Protocols Over IP Enterprises, Education, Government Agencies and Organizations use the IPTube·E2's tunnel to transport legacy LAN protocols, such as NetBEUI, IPX, AppleTalk and Decnet, over very cost effective IP only based services. Legacy applications that utilize non routable protocols are able to access services across an IP point to point connection.

IP Bridge The IP-Tube E2 transparently monitors all the packet traffic on its internal LAN segment to determine whether the packets it receives are to be forwarded. The Ethernet MAC layer source addresses that are active on the internal LAN are stored in a filtering database. Packets with a MAC destination that do not match a MAC address entry for the receiving port are encapsulated in an IP packet that is forwarded to the remote network. MANAGEMENT The IP·Tube E2 management is accomplished with a Command Line Interface that is accessed through a Console or Telnet connection. Templates of the most common configurations provide for an Edit and Paste configuration. SNMP MIB I and II support with interface status change traps. Secure Communication The IPTube·E2 provides a high level of security by only exchanging packets with the remote network. Additionally Ethernet Frames within the IP envelope must be addressed to specific Ethernet MAC addresses. Bridges secure applications that limit communication to IP addresses within the same subnet across an enterprise Intranet. Network Security Security is established with Full On Source, Destination Address; Port and Flag IP Packet filtering. Interconnectivity is selectively controlled at the interface, network, device and application layers.

Technical Specifications

LAN Network Interface: • Two 10/100 BaseT Full/Half Ethernet • Autonegotiation or Configurable Speed    and Duplex LAN Network Protocols Supported: • IP, TCP, UDP, ICMP Regulatory: • Safety -IEC60950 • EMC - CFR 47 Part 15 Sub Part B:2002             EN55022:1994+A1&A2             EN55024, ICES-003 1997             CISPR 22 Level A • CE Dimensions: • 14" (L) x 5.5" (W) x 2.50" (H) TFTP Upgrade Capable (Flash ROMs): · IPTube is operational during upgrade Management: · Telnet support with Edit and Paste Templates · Console Port for Out of Band Management · SNMP support (MIB I, MIB II) · Remote configuration, monitoring, & reset Console Port: · RJ45 to DB9 Female DCE adapter shipped with product. Enables direct connection to Com1. Power: · 15VDC, 1.6A; International Adapters Available · 24-36 VDC Optional · -48 VDC Optional • Hot Standby with 2nd Power Module

Home     |     About Us     |    Products    |    Testing Instruments
Contact Us    |    E-mail

Bhumika International Inc
Mississauga, Ontario, Canada
Phone: + 1 (416) 930 2931
E-mail: info@bhumika.ca
Website: http://www.bhumika.ca

Technical Specifications are subject to change without notice.
Windows is the registered Trademark of Microsoft Corporation, USA.
All other trademarks are the ownership of their respective owners.